Wall shop:
1.The first wall base with water wet, when there is no water on the surface, can be used as binder construction.
2.In the specified time to paste the marble, paste to slightly twist and up and down rub marble, or with a mallet gently knock, make marble and adhesive close together.
3.Calibrate the joints between the horizontal and adjacent plates, and note that 2mm or more joints should be reserved between the marbles.
4.Preliminary cleaning attached to the surface of the board dirt, paste good marble 3 days before the seam, seam filling treatment, seam filling should use artificial marble special sealant.
5.After caulking treatment, timely clean caulking materials and dirt attached to the plate surface.
6.After the marble shop paste, after the acceptance and cleaning to tear the protective film.
7.It is recommended not to use the traditional marble wet hanging construction.
Floor tile:
1. Wet the ground surface with water first, and then use as binder when there is no clear water on the surface.
2.Confirm that there is no clear water on the base, special artificial stone adhesive for batch scraping (strip shape/full batch scraping) thickness of more than 3mm, the back of stone is the same, thickness of 2-3mm, and then paste stone.
3.In the specified time (according to the requirements of the adhesive product instructions) paste stone, stone on the shop, with a mallet gently knock, so that the new paste artificial stone can be completely close to the adhesive.
4.The joints between horizontal and adjacent plates shall be corrected. (seam filler construction) notice that 2mm or more joints shall be reserved between stones.
5.Paste good stone after 3 days (can according to the use of special artificial stone adhesive instructions) can be clear seam, seam filling processing, seam should use special artificial stone sealant.
6.After caulking treatment, clean the caulking material and dirt attached to the plate surface (acid and alkaline cleaner is not allowed, and special artificial stone cleaner is recommended).
7.Precautions: when large area pavement is installed, 5-8mm expansion joints should be set at a proper interval of 8-10 meters.
8.After the stone paving, the film will be torn after acceptance and cleaning.
